Can You Use A Table Saw As A Jointer

Youll also need a 60 inch long strip of stock ripped to dimensions of about 34 x 38 inch but you can use pretty much any straight piece of scrap stock for this piece.

Can you use a table saw as a jointer. In this article well show you our version of a jointer jig. Remember that man made materials like plywood can be hard on steel jointer knives but not on carbide table saw blades. You can joint boards with a table saw. Table saw obviously drill tool.

Even if you own a jointer youll want to master this technique. You cant use the fence because unless it is long enough that both ends of the board are in constant contact with it and you put the concave surface against the fence youll just end up duplicating any imperfecti. You need a really straight piece of plywood at least 3 or 4 inches wide and a couple of small nails. As you can imagine space and money are the bottleneck of what tools i acquire.

Melamine scrap mdf or plywood screws andor wood glue clamps. The jig isnt as good as a jointer you cant adjust. Its easy to make and very effective. If you dont have a jointer but you do have a table saw then this tablesaw jointer jig can get you by.

Make a jointer jig for the tablesaw. Measure the length and width. To begin building your table saw jointer jig youll need a piece of 34 inch plywood measuring 12 inches wide by 48 inches in length and a 1 x 6 cut to 36 inches in length. To a degree but it isnt easy.

You use the nails to tack the plywood straightedge on the back side of the board youre wanting to joint. With the addition of a simple shop made fence you can easily edge joint on your table saw. As long as you have a table saw the heart of any woodshop then you can get by.